20feetof 1½-inch wide ribbon in a contrasting coloroptional
scotch tape
T-pins or floral pins
Instructions
If you are using 2 ribbons, layer the narrower ribbon on top of the wider one. Staple them together about every 6 inches along the length.
Attach the ribbon to the wreath form by folding the end of it around the inside wire close to the bottom of the heart. Make sure the end of the ribbon is at the back of the wreath. Then staple or tape it in place.
Wrap the ribbon around the wreath form by angling it up toward the top. Make sure to overlap the edges are you continue wrapping until you get back to the starting end.
Cut off the end of the ribbon at the back of the wreath. Staple the end in place. Then put a piece of tape across the end of the ribbon to prevent it from unraveling.
Stick a T-pin or floral pin into the top of the wreath at the back. The thickness of the ribbon should hold it in place.
Hang the wreath on a wall or the front door with a small nail.